My notes from this Short
01
A saw wave bent with Bend+
I start off with the basic shapes, a saw wave, set the warp mode to Bend+ and just bend it. Then I take envelope 2 and shape it. It's very important.
02
A German low pass from 120 hertz
In the filter section I want the German low pass. I completely squash the drive, add resonance and make it start at around 120 hertz.
Envelope 2 is added slightly, and then I add envelope three, a little bit shorter, on top of it.
03
Stompbox and velocity on the cutoff
I take distortion, put it on Stompbox, completely squash the drive and put it on mono. Make sure the velocity is mapped to the cutoff, so it responds to whatever is happening in the piano roll.
Feel free to add some reverb and delay, and a compressor with a low threshold to make it snappy.
What I use in this video
Want the full version?
How to Make Acid Sounds in SerumFull tutorial, 10:19Access hundreds of techno sounds, presets & project files
Want some free packs? Unlock our freebie vault.
We only send you techno content. Unsubscribe anytime.
Open the Freebie Vault
